SHOPVALVES / Catalog
Product
Spirax Sarco UTDS46M Thermodynamic Steam Trap
Spirax Sarco UTDS46M thermodynamic steam trap with a maximum operating pressure of 46 bar g. Designed for quick installation on steam, air, or condensate systems using pipeline connectors.
Spirax Sarco WS4 Water Seal Pot
Spirax Sarco WS4 water seal pot for use with DRV or DEP actuators when the medium temperature exceeds the actuator operating range. WS4-3 is recommended for applications with rapid pressure or load changes.
Spirax Sarco AVM7 Clean Steam System Air Vent
Spirax Sarco AVM7 is a repairable clean steam system air vent designed to remove air and other non-condensable gases from clean steam systems. Operating temperature is close to steam temperature, with a 316L stainless steel construction and an internal surface finish of approximately Ra1.6 - 3.2.
Spirax Sarco LE63 Stainless Steel Two-Port Control Valve DN15-DN100 PN16 Equal-Percentage Flow Characteristic Steam, Liquid and Gas Control Valve
Spirax Sarco LE63 is a stainless steel two-port single-seat globe control valve for modulating or on-off service in steam, liquid and gas applications. Its equal-percentage flow characteristic provides precise control across the full flow range.
Spirax Sarco LCV1 Bronze Lift Check Valve
Spirax Sarco LCV1 bronze lift check valve for horizontal pipeline installation to prevent reverse flow.
Spirax Sarco DP163/DP163G/DP163Y Stainless Steel Body Pilot-Operated Pressure Reducing Valves
Spirax Sarco DP163, DP163G, and DP163Y are pilot-operated diaphragm pressure reducing valves with stainless steel bodies. DP163 is designed for steam systems, DP163G for compressed air and other industrial gases, and DP163Y for disinfection and sterilization applications.
Spirax Sarco LCS3050 Single-Probe Low-Level Switch
Spirax Sarco LCS3050 is a single-probe low-level switch used with LP40 level probes to limit the water level in steam boilers and (pressurized) hot water installations. When the level falls below the preset minimum, the switch safely shuts off the heating.
Spirax Sarco EP5/ISP5 Electrical Intelligent Positioner EP5 Positioner
Spirax Sarco EP5 electropneumatic positioner is a 2-wire positioner requiring a 4 - 20 mA input signal for linear pneumatic actuators.
Spirax Sarco SX25 Process Controller
Spirax Sarco SX25 Process Controller is a high-precision 1/16 DIN panel-mount controller from renowned UK steam system brand Spirax Sarco.
Spirax Sarco FT44-10 Carbon Steel Float Steam Trap DN80/DN100
Spirax Sarco FT44 carbon steel float steam trap for DN80 and DN100 applications, with an integral automatic air vent, flanged connections, and horizontal installation only.
Spirax Sarco Fig16 and Fig16L Austenitic Stainless Steel Y-Strainers
Spirax Sarco Fig16 and Fig16L Y-strainers are made of austenitic stainless steel with threaded connections. Fig16 uses AISI 316, while Fig16L uses AISI 316L. The standard stainless steel screen has a 0.8mm perforation size, with other perforation sizes, mesh ratings, and Monel alloy screens available.
Spirax Sarco PA20 Preamplifier
PA20 preamplifier for Spirax Sarco capacitive sensors, providing a voltage output proportional to level and compatibility with all Spirax Sarco voltage-input controllers and transmitters.
Spirax Sarco TDS46M Thermodynamic Steam Trap
Spirax Sarco TDS46M thermodynamic steam trap with a replaceable seat. Operates up to 46 bar g for low capacity steam applications.
Spirax Sarco CP10 Sensor
Spirax Sarco CP10 conductivity sensor for total dissolved solids (TDS) and conductivity control systems.
Spirax Sarco MV11/MV14 Solenoid Valve
Spirax Sarco MV solenoid valve is a pilot-operated solenoid valve with a NAMUR connection, primarily designed for use with BVA300 pneumatic actuators.
Spirax Sarco DF2 Silencer
Compact DF2 silencer for installation downstream of steam traps discharging condensate into condensate recovery lines; it reduces noise and prevents water hammer caused by flash steam.